Everbuild Anchorset Red 380P Polyester Resin - 380ml Anchorset is a rapid curing one shot two-part chemical anchoring cartridge system based on an unsaturated polyester resin in styrene. Applied in one single action to produce a cost effective, tough, chemical resistant fixin...Read More
Everbuild Anchorset Red 380P Polyester Resin - 380ml
Anchorset is a rapid curing one shot two-part chemical anchoring cartridge system based on an unsaturated polyester resin in styrene. Applied in one single action to produce a cost effective, tough, chemical resistant fixing. Anchorset is ideal for close-to-edge applications unlike expansion anchors as no stress is placed on the surrounding substrate. Versatile in use, anchorset is suitable for fixing wall tiles, starter bars, studs, bolts or large screws in a wide range of substrates including brickwork, concrete, masonry, stone and PFA blocks. Hollow base materials can be securely fastened into by using anchorset in conjunction with a sleeve or sieve.
Attach the mixing nozzle to the cartridge, screw down hand tight. Place cartridge into the anchorset dispensing gun. Open the cartridge by pressing the green end of the colour coded valve. Gradually pressurise the cartridge by activating the hand trigger a few times until material passes through the mixing nozzle. Stop pressurising to allow the material to flow until an even colour is obtained, approximately 5 to 6 inches of extruded material should be adequate. Press the red end to close to the valve. Insert the nozzle into the base of the hole and open valve again by pressing the green end and activate the trigger, withdraw the nozzle slowly as the hole fills. Once the required fill is achieved shut off the valve and wipe excess material. Insert the fixing slowly slowly with a rotating action to the desired depth. Once all applications have been carried out, release the pressure by pressing the slide release arm on the back of the trigger stop and pulling back the slide rail.
Please note once material has started to extrude through the nozzle over pressurising the system will not increase the flow rate and can cause leakage from the rear of the cartridge.
Store in a dry area between 5 and 25°C and do not expose to sunlight. Storage at higher temperatures will reduce the shelf life.
12 months from date of manufacture.
There are no product specifications to show.
There are currently no questions for this product.
Pay in 4 interest-free payments of £11.56
Learn moreStart right away with 4 months to pay
Enjoy 0% over 4 monthly instalments*
* Subject to status. Minimum spend required. T&Cs apply.
It seems you are running an older version of Internet Explorer. Our site does not support these old browsers as they do not house the technology that allows our site to be safe and secure.
If you wish to access our site please either upgrade your browser or download an alternative.
